Almost all remaining B3 battle droids were shut down at the end of the Clone Wars after Darth Vader's massacre of the Separatist Council. They were referred to as 'clankers' by the Clone. During the Clone Wars, these droids would charge towards their enemies, firing their blasters.
#Star wars b3 battle droid series
Unbeknownst to both sides, Supreme Chancellor Palpatine had actually revealed the location of the factory because he feared that B3 ultra battle droids could potentially prolong the war. The B1 Battle Droids were a series of combat droids used by the Separatists during the Clone Wars until they were outlawed by the Galactic Empire, After Clone Order 66 and The Great Jedi Purge, the whole battle droid army was given a shutdown command. Despite being used by three factions, the Separatists used these droids the most, often mass producing them so they could. Around two months before the end of the Clone Wars, the only factory B3 battle droids were constructed in was destroyed. The B-series Battle Droid line, often shortened to the B-series, is a heavily mass-produced series of battle droids that were created by the Trade Federation, Techno Union and the Confederacy of Independent Systems and they were used up to and during the Clone Wars.
This made several Separatist leaders skeptical of the new battle droid, although General Grievous believed the B3 could be a turning point in the war.īy the time of the Outer Rim Sieges, the design had been improved, although it was still unpopular amongst many Separatist commanders due to the droid's previous flaws and the droid was expensive to produce.
While the ultra battle droid proved to be a powerful fighting machine, many units were plagued with various technical problems. Although the B3-s massive height often intimidated opponents, this also made the ultra battle droid a large target, and transporting a unit was also difficult.Īn evolution of the B2, the B3 ultra battle droid was designed by Baktoid Combat Automata and first deployed approximately halfway through the Clone Wars. The B3 featured a red sensor along with green or dull silver plating and measured 4 meters in height. The B3 additionally had a missile launcher located to the left of the droid's neckless head. Two smaller arms were located underneath the primary ones, and these boasted a rapid-fire blaster cannon similar to the one found on the B2 battle droid. The ultra battle droid had two large arms that featured a devastating plasma cannon on the left hand and a flamethrower on the right. Manufactured by Baktoid Combat Automata, the B3 ultra battle droid was based upon the design of the B2 super battle droid, although the B3 was over twice as large and boasted many more weapons. The B3 ultra battle droid, also known as the ultra battle droid, was a powerful experimental battle droid model utilized by the Confederacy of Independent Systems during the Clone Wars.